kernel=9picpuf
#kernel=uboot.img
gpu_mem=16
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
disable_overscan=1

# uncomment the following to adjust overscan.  Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=-16
#overscan_right=-16
#overscan_top=-16
#overscan_bottom=-16

# uncomment to force a console size.  By default it will be display's size minus
# overscan.
#framebuffer_width=1920
#framebuffer_height=1080

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI.  This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm.  700 MHz is the default.
#arm_freq=800

# for more options see http://elinux.org/RPi_config.txt